Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

MASSIVE fluctuation problems

Status
Not open for further replies.

szczepan

Newbie level 3
Newbie level 3
Joined
May 22, 2011
Messages
3
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,297
i got a problem, when i finally finished everything nothing worked i saw that my solder was just touching the neg power to pos power so i de-solder the IC to check if it works but on a 1.5 volt battey i'm getting .8 to 4 to 8 then back to 2, is the chip fried?
 

Admittedly I am new to this forum, but I can't find any clue to what IC or circuit or project you are asking about.
 
oh my bad..the ic7107clp chip, i found out i diagrams shown ho to make it is just a guide line cause you gotta do some tweeks to make it run perfectly but im getting a better results so hopfully its no fried
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top