1. What is the minimum mV per step ?
Depends on Vrhi and Vrlo. Step size is (Vrhi-Vrlo)/10
2. How much current required at pin 5 ?
You should really read data sheet. 100nA max.
3. Current for one LED is equal to current from REF OUT x 10 ?
In the example, set REF OUT to 1mA. So current flow 10mA per LED.
Again, clearly stated in data sheet. Iled=12.5/R1 (page 2)
4. REF OUT is regulate and limit at (V[/b][/size]+ - 1.5 ) < 12 volt ?
I want to design a generic circuit for all perposes.
Yes.
- Use voltage divider for SIG IN.
- No need to adjust REF HI. Use REF OUT as REF HI.
- Can set offset (REF LOW) in full range (0 to REF OUT).
Main problem with low step voltage is offset error or comparators. Typical 3mV seems high for just 20-30mV step. Note that maximum offset might be higher.
Use appropriate amplifier for input scaling.
And for last question, yes, 100kΩ pot can be used, but you still have problem with offset.
For small signal you should use precision opamp like OP177, OP07 or simillar to scale it up and avoid problems with offset error and drift LM3914 would cause.[/