Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Magnet assisted transformer

Status
Not open for further replies.

Kajunbee

Advanced Member level 1
Advanced Member level 1
Joined
Nov 5, 2016
Messages
456
Helped
93
Reputation
186
Reaction score
105
Trophy points
1,323
Activity points
5,132

Assuming there are no tricks I was wondering if anyone had and explanation for what is happening. The only information is that transformer is fed with 50 percent square wave and amp meter reading.
--- Updated ---

I read the comment section and the third reply seemed reasonable but would like to know experts thought. Or is video faked somehow.
 
Last edited:

Is it asking too much to expect a brief description of the test setup?

Anyway, if the core is biased with a strong static field, the magnetization current becomes asymmetrical, thus showing an average DC component. I won't name it DC transformer.
 

    Kajunbee

    Points: 2
    Helpful Answer Positive Rating
i think FvM is correct - adding the magnet tends to bias the magnetization of the core, etc

the comments on you tube that imply you can get something for nothing are wrong.
there is no free energy
there are in fact losses n the core, wires, motor, etc, so you always get out less than you put in.
 

    Kajunbee

    Points: 2
    Helpful Answer Positive Rating
I think sometimes about whether a undirectional transformer
(like flyback) could be run at higher current density, if the
core were biased against normal current polarity so as to
use 2 quadrants rather than one, for double the B-H swing.

Or, whether a pre-magnetized core would be of any benefit
in the same way. But not enough of a magnet-head to know
whether this is a thing, a done thing or a nothing.
 

    Kajunbee

    Points: 2
    Helpful Answer Positive Rating
I think sometimes about whether a undirectional transformer
(like flyback) could be run at higher current density, if the
core were biased against normal current polarity so as to
use 2 quadrants rather than one, for double the B-H swing.

Or, whether a pre-magnetized core would be of any benefit
in the same way. But not enough of a magnet-head to know
whether this is a thing, a done thing or a nothing.
They are real parts: https://ieeexplore.ieee.org/documen... given inductor current and inductance rating.
 

    Kajunbee

    Points: 2
    Helpful Answer Positive Rating

I was able to find this video that demonstrates the effect a static magnetic field has on transformer. I was hoping to find some information on unidirectional square wave pulsed coils but no such luck. If there is any disagreement on content of video I would interested to hear them.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top