hajeur
Newbie level 4
- Joined
- Apr 11, 2014
- Messages
- 5
- Helped
- 0
- Reputation
- 0
- Reaction score
- 0
- Trophy points
- 1
- Activity points
- 34
Hello guys,
As i'm novice in developing embedded software ,i find some troubles in designing the encapsulation of the industrial protocol M-Bus(transport layer,osi model;based on RS485 serial link,half duplex )in the serial point to point protocole RS232/UART (physical layer,osi model;full duplex)in order to send the data afterward over an XBEE .
Honestly,i’s been three days since i was searching on the net for a way to get that done but right now i’m wondering if that is even really possible to design .
Hajeur
PS:it's a domotic project
As i'm novice in developing embedded software ,i find some troubles in designing the encapsulation of the industrial protocol M-Bus(transport layer,osi model;based on RS485 serial link,half duplex )in the serial point to point protocole RS232/UART (physical layer,osi model;full duplex)in order to send the data afterward over an XBEE .
Honestly,i’s been three days since i was searching on the net for a way to get that done but right now i’m wondering if that is even really possible to design .
Hajeur
PS:it's a domotic project