load pull simulation

Status
Not open for further replies.
S

sinato

Junior Member level 2
Joined
Jan 4, 2013
Messages
23
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Visit site
Activity points
1,422
I use port adaptor in cadence but the problem is it takes very long time also some points shows instability and simulation might not continue ..i want to know how to deal with these issues
 

Is your problem in how to use the software to do load pulling, or in how to change your circuit so that it remains stable under certain mismatched load?
 

I want to know how to determine specific region on smith chart so as not to vary the magnitude and phase on the whole smith chart , also I want to know how I could conjuctly match large signals
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…