omelfata
Newbie level 1
Hi everyone,
I am trying to join two links on a router for increased bandwidth (ie. Link aggregation, Link aggregation - Wikipedia, the free encyclopedia)
I have been trying for the past 4 hours with no luck
I have a very basic campus topology with two routers, two switches and one node and one FTP server.
here is a picture:
I am using basic RIP and I've setup the aggregation from the IP>IP Routing Parameters> Aggregate Interfaces . The only fields I changed where the IP address, and the Routing Protocol (set it to RIP).
I then set the interfaces (where the links are connected) to support this Aggregate profile.
I am very surprised at how poorly OPNET is documented, any advice?!
other info:
I have RIP and LACP simulation efficiency disabled
This is an Ethernet network
I am trying to join two links on a router for increased bandwidth (ie. Link aggregation, Link aggregation - Wikipedia, the free encyclopedia)
I have been trying for the past 4 hours with no luck
I have a very basic campus topology with two routers, two switches and one node and one FTP server.
here is a picture:
I am using basic RIP and I've setup the aggregation from the IP>IP Routing Parameters> Aggregate Interfaces . The only fields I changed where the IP address, and the Routing Protocol (set it to RIP).
I then set the interfaces (where the links are connected) to support this Aggregate profile.
I am very surprised at how poorly OPNET is documented, any advice?!
other info:
I have RIP and LACP simulation efficiency disabled
This is an Ethernet network
