kingcobe
Newbie
Hello edaboard forum, anyone knows this circuit? i try to make design but i dont know if its correct, please check my design below
using tinkercad i make this design, do you think its correct? and please tell me where should i put pin 2 and 15 of l293d to lm358/here on the design. The green led is the IR receiver while the gray/white is the IR transmitter, thank you eda forum
up
using tinkercad i make this design, do you think its correct? and please tell me where should i put pin 2 and 15 of l293d to lm358/here on the design. The green led is the IR receiver while the gray/white is the IR transmitter, thank you eda forum
--- Updated ---
up
Last edited: