length matching guidlines

Status
Not open for further replies.
P

patilpradeep

Junior Member level 1
Joined
Apr 4, 2013
Messages
15
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Visit site
Activity points
1,364
Hi All,

is it important to match length of address signal with data signals for Flash & PROM interfaces????
 

anilrock87 said:
Hi,

I suggest you to go with the design guidelines provided by the manufacturer.

Regards
Anil
Click to expand...

Hi Anil,

In the datasheet I am not able see any length matching guidlines. So Pls suggest me how can I go ahead....
If you have any general guidlines then Pls share with me.


Regards,
Pradeep
 

sivamani said:
May not be required.Just check the setup and hold margins from the datasheet..
Click to expand...

thanks sivamani,

I have one more question , some the traces are traveling bellow the SMD oscilator in my design. is this ok or not?
 

Without a ground layer in between? Not good design practice. The oscillator may introduce noise on the signal line or the signal line may interfere with the oscilator...
 

could you please let me know ur layer count , stackup order and in which layer it is routed..As for Ice-Tea suggested there should be some isolation to avoid noise pickup..
 

sivamani said:
could you please let me know ur layer count , stackup order and in which layer it is routed..As for Ice-Tea suggested there should be some isolation to avoid noise pickup..
Click to expand...

12 lyr Board. signals are traveling in 3rd layer(inner) & 2nd layer is Ground plane.
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…