[SOLVED] LCD not displaying anything with AT89C52

Status
Not open for further replies.
S

shigha

Junior Member level 1
Joined
Apr 13, 2013
Messages
19
Helped
3
Reputation
6
Reaction score
3
Trophy points
1,283
Visit site
Activity points
1,392
My LCD is only showing the backlight. No characters are shown. while working, I checked the microcontroller pins and they are all working properly. While connecting LCD, i have not given any resistance to backlight. Is that a problem? Would that cause, my LCD to burn?
 

Yes Iam doing project on breadboard. The proteus simulation was ok. TO CHECK MY LCD, I just connected 16 pin to gnd and 15 pin to +5v. Only backlight was lit.?

- - - Updated - - -

This is my code

- - - Updated - - -

Iam using JHD162A
 

Attachments

  • code.doc
    67 KB · Views: 60

What is HS OSC

- - - Updated - - -

TO CHECK MY LCD, I just connected 16 pin to gnd and 15 pin to +5v. Only backlight was lit.There was nothing on any rows
 

Attachments

  • code.txt
    9.7 KB · Views: 53

You are describing pin 15 and pin 16, hope you have connected the data and control pins as well. Without these connection and some timing and delay manipulation you cant expect any thing on display. It would have been nice if you could have attached the circuit schematic so that experts could come up with to the point solution.
 

I got my problem. It was the pin 3. It must be connected to ground for high contrast of characters
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…