MedicMamat
Newbie level 6
Hi
I try to drive a laser diode, ML520G72 (Mitsubishi) with an iC-HG integrated circuit
driver, setting the current at about 280mA. however i failed to see any light out of it.
when i soldered the laser diode i was grounded and connected the pins very fast. i
could not figure out what really went wrong.
has anybody any experience on that?
Thanks
I try to drive a laser diode, ML520G72 (Mitsubishi) with an iC-HG integrated circuit
driver, setting the current at about 280mA. however i failed to see any light out of it.
when i soldered the laser diode i was grounded and connected the pins very fast. i
could not figure out what really went wrong.
has anybody any experience on that?
Thanks