therealzian
Newbie level 1
Hi, I am a newbie for LabVIEW, I have a question about the ADC conversion as below.
First, my flexiforce sensor circuit output is analog signal then it has been gone through the WSN DAQ unit and turned into digital signal.
Then when the signal has been transferred into my laptop with Labview on running, i have to do the conversion back to the analog signal.
which in my case, is voltage output from circuit, and i wanna read voltage in labview. How am i going to do the conversion? Thanks.
First, my flexiforce sensor circuit output is analog signal then it has been gone through the WSN DAQ unit and turned into digital signal.
Then when the signal has been transferred into my laptop with Labview on running, i have to do the conversion back to the analog signal.
which in my case, is voltage output from circuit, and i wanna read voltage in labview. How am i going to do the conversion? Thanks.