Keysight ADS P_1Tone

Status
Not open for further replies.
O

oumik

Junior Member level 1
Joined
Apr 24, 2023
Messages
15
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
88
When I plotted the dBm(RF_IN) I obtain -9 dBm right after the RF source which is set at 0 dBm (see images below) . I do not understand why I did not obtain 0 dBm in the plot.

 

Sort by date Sort by votes
"dBm" function assumes that the Voltage over the Impedance is 50 Ohm but your case is different.
If you know the Impedance when you look into the circuit, you have to use dBm(RF_IN,Impedance).
But there is simpler method. Use P_Probe element to measure the Power that gets into the circuit.
 
Upvote 0 Downvote
Thank you for your answer. I tried using the P_Probe1 but I get 0.2691 mW instead of 1mW (0 dBm).
 

Upvote 0 Downvote
oumik said:
Thank you for your answer. I tried using the P_Probe1 but I get 0.2691 mW instead of 1mW (0 dBm).
Click to expand...
So there is a Mismatch between the Source and the Circuit.
Because 0 dBm is Available Power from the Source. Not Entered Power.
If you design a good matching circuit, this entered power will be same as Available Power.
 
Upvote 0 Downvote
Thank
BigBoss said:
So there is a Mismatch between the Source and the Circuit.
Because 0 dBm is Available Power from the Source. Not Entered Power.
If you design a good matching circuit, this entered power will be same as Available Power.
Click to expand...
Thank you for your answer. I have managed to increase the value to 0.9 mW by adding a microstrip line in series with an inductor in series with a resistor. Is this configuration valid since I have not based it on any available matching circuit configuration ( I just added them arbitrarily)?

 

Upvote 0 Downvote
You need to choose a capacitor.
 

Attachments

  • 1.jpg
    50.8 KB · Views: 155
Last edited by a moderator:
Reactions: oumik

    O

    oumik

    Points: 2
    Helpful Answer Positive Rating
Upvote 1 Downvote
Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…