[AVR] JTAG interface to AT90PWM3

Status
Not open for further replies.

Dinuwilson

Advanced Member level 4
Joined
Aug 20, 2011
Messages
100
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,298
Visit site
Activity points
1,985
Hai......i got new avr JTAGICE mkll debugger. i need to connect this to AT90PWM controller for debugging..when i check pin out of AT90PWM3 there is no TCK,TDO,TMS lines.. How can i connect? if you got something ..please share it
 

So you may not be able to use the mkII debugger with the AT90PWM3 micro.
Click to expand...
I suspect a misunderstanding, unless you know better.

PWM3B is the recent, corrected chip version of PWM3, the latter may be just omitted from the mkii devices list. There are no other indications that the chip can't be used with mkii.
 

FvM said:
I suspect a misunderstanding, unless you know better.

PWM3B is the recent, corrected chip version of PWM3, the latter may be just omitted from the mkii devices list. There are no other indications that the chip can't be used with mkii.
Click to expand...

I haven't used MK II with AT90 series controllers ... but i went by the list of controllers the debugger supports. I was not fully aware if they are different or revisions of the chips. It looks like debugger be able to program AT90 series controllers using debug wire and SPI lines.

Attached is the wiring diagram for debugger to micro. Hope this helps.
 

Attachments

  • JTAG ICE MK II_AT90PWM_Connections.JPG
    33 KB · Views: 83

Thank's for your replay........ i connected same as like the wiring diagram and unit start working both in isp mode and debugging mode......
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…