Issues with SPI Flash

Status
Not open for further replies.

soumen21

Member level 5
Joined
May 7, 2011
Messages
82
Helped
3
Reputation
6
Reaction score
3
Trophy points
1,288
Visit site
Activity points
1,807
Dear Sir,

I have used ATMEL made SPI flash AT45DB321D. The design is working fine.

Recently Adesto acquired ATMEL's flash business and the part is sold with adesto's name. I got some adesto parts and currently observing few failure rates with the new part. Sometimes the flash contents are getting erased. What could be the reason ?

Regards
Soumen
 

It may happen that the design is on the edge. Then small changes in the device parameters like timing or output drive level can cause such failures on some parts. I worked with these flash devices too and I have noticed that on a typical 1.5mm 2-layer board they require good power supply decoupling and some simple impedance matching method like resistors 33-100 ohm in series with the signal lines, the clock signal especially.
 

Status
Not open for further replies.

Similar threads

Cookies are required to use this site. You must accept them to continue using the site. Learn more…