Issues regarding Simulink

Status
Not open for further replies.
T

timbu007

Junior Member level 1
Joined
Feb 6, 2010
Messages
15
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,400
Dear All,
I am working on FFT plot for an ADC.While plotting i figured out that the input signal which is a sine wave is not providing the actual sine wave output.On verification of the FFT for the sine wave signal there is a spike at a vale of 3.3*10e8 .Attached is the figure. I am giving an input sine wave of 100e6*2*pi rad/sec using the sine wave generator block in Simulink. Any suggestions.Is it because of any conversion issues regarding frequency to radian sec.In the fft code my clock frequency is given as 1e9.
Really need our suggestions on this issue.
Thanks.
 

Attachments

  • inputfftspike.jpg
    31 KB · Views: 114

Ahh...
Sorry to tell ya, but 100e6*2*pi =~ 3.3*10e8

Or am I missing something?
 
Dear Sir,
Thank you for bringing that to my notice.
I wanted to know how does the input frequency change the SNR of the ADC.In my case the SNR varies from negative to positive value as and when I change the input frequency at the sine wave generator.

Regards
Tim
eladla said:
Ahh...
Sorry to tell ya, but 100e6*2*pi =~ 3.3*10e8

Or am I missing something?
Click to expand...
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…