issues on pins output,sg 3524 as used in an inverter.

Status
Not open for further replies.
E

Emmanuel Akujobi

Newbie level 5
Joined
Aug 14, 2013
Messages
9
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Visit site
Activity points
60
good evening everyone,please my sg3524 pin 14 and 11 output are misbehaving,1 need a frequency of 50HZ which i was able 2 get but the voltage at that pins are 0.5v which i was not able to increase,even if i want to use a driver incorporating a transistor,it means i need a good amount of current to drive them,but with d output am having i can achieve that,please i need assistance,thanks.
 


Hi Emmanuel
Post the schematic which you have exactly went through .

Best Wishes
Goldsmith
 

power_inverter_op_enlarged.gif,
this is the picture,i mean the circuit
Click to expand...

Hi Emmanuel
Your circuit is dealing with some problems . try to fix them then everything will be ok .
1-decrease value of resistors which are series with gate of mosfets . 2.2 k is absolutely high and must be decreased . try 10 ohm .
2- use a totem pole before gate of your mosfets .
3 - use two 470 uf electrolytic capacitors in parallel together and tie them through the ground and middle head of your transformer ( exactly nearby that ) .
4- use a 10 k ohm resistor in parallel with GS of each mosfet .
i.e : this circuit must not be without load because your mosfets will be burned suddenly .

Test these things and let me know the result .

Good Luck
Goldsmith
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…