I need to interface a thermal printer with microcontroller. But I have no idea about thermal printer. Any one have information about thermal printer help me please..
Added after 3 hours 45 minutes:
Is there any commands needed for printing a character using thermal printer.
Added after 7 minutes:
anybody have schematic for interfacing thermal printer with microcontroller
I was used 2 types of comunication at FUJITSU thermal printer : Serial and parallel.
The easiest was obviously serial, but speed was limited against parallel type. In case, I had need to print biometric signal at real-time.
The most trusteable printer I used was a GSI, but it protocol is very hard to use.
Hi Andre. I am using FTP-638MCL103 and FTP-628MCL103 and trying to interface the same with a controller. Although i was able to know how to work with the stepper motor but I am unable to understand how the printing stuff works. I do have the datasheet but i hardly can figure out how to do this. Would u be able to guide me on this?