mircograss
Newbie level 1
Hi all,
This is my first message here.
I'd like to know if anyone has had an experience in using an Intel 31154 bridge.
We are using this bridge to "bridge"
a 64bit PCI-X bus to a 32bit PCI bus.
I'm a little bit concerned about the documentation, where I cannot well understood
how to properly set the the buses' width for both sides.
I mean, it seems that some pull-ups must be added to the higher 32bits while not used &| not driven, but is this the only way to "inform" the component?
Thanks in advance to everyone who has sorta answer.
Regards,
MG
This is my first message here.
I'd like to know if anyone has had an experience in using an Intel 31154 bridge.
We are using this bridge to "bridge"
a 64bit PCI-X bus to a 32bit PCI bus.I'm a little bit concerned about the documentation, where I cannot well understood
how to properly set the the buses' width for both sides.
I mean, it seems that some pull-ups must be added to the higher 32bits while not used &| not driven, but is this the only way to "inform" the component?
Thanks in advance to everyone who has sorta answer.
Regards,
MG