Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

integrating uC 89s51 with wireless link using linx kh2

Status
Not open for further replies.
S

saraheem

Newbie level 5
Newbie level 5
Joined
Dec 21, 2009
Messages
9
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,346
Hi...

I am using at89s51 uC. For wireless link i am using linx kh2 transmitter and its corresponding kh2 receiver.

In writing the program for this setup, i need to know when exactly i should read the data. The Rx ic gives a data valid signal when there is a valid transmission. I am giving this to uC as Int0. After how much time should i read the data lines of the receiver to get the correct data?

Thank you in advance...
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top