Reply to thread

Hello,

I would like to simulate the system {connector1 + 24 inches cable + connector2}, something like this :

[ATTACH=full]193737[/ATTACH]

Obviously, I cannot simulate this because of the computing cost....

But under HFSS, I can use deembedinbg using wave ports (but not using lumped ports) so my idea is to simulate :

 - the S-parameters of the connector1 inputs / output

 - a little length of cable using wave ports

 - dembed to get the 24 inches lenght of cable

 - the S-parameters of the connector2 inputs / output (which are the same as connector1)

 - Add all the circuits in series

[ATTACH=full]193738[/ATTACH]

I am just wondering if I can add the S-parameters circuits in series and if it is correct to add them to get the total system s-parameters ?

Thanks you for your advice