In cadence, how to resimulate the transient simulation from the point of completion?

Status
Not open for further replies.
M

mssong

Junior Member level 2
Joined
Jul 25, 2023
Messages
22
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
190
I ran cadence's transient simulation for 1s and got the waveform.

Is it possible to run the simulation for only 1 second, starting from the part of the simulation (1s) and ending at (2s), without simulating the previous part (1s)?
 

Solution
D
In the transient analysis setup you can save final operating point,
and somewhere in there you can also set an initial condition file
and a start timepoint. You may need to suppress DC initial
condition to force using the tran final OP instead (been a while
since I have done chained tran analyses). It's all in there though.
Sort by date Sort by votes
In the transient analysis setup you can save final operating point,
and somewhere in there you can also set an initial condition file
and a start timepoint. You may need to suppress DC initial
condition to force using the tran final OP instead (been a while
since I have done chained tran analyses). It's all in there though.
 

    M

    mssong

    Points: 2
    Helpful Answer Positive Rating
Upvote 1 Downvote
Solution
Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…