Kuz9l
Newbie
Hello, I have a project that was made in innovus. I uploaded the .def file.
In cadence allegro I would like to create a die according to the size of the PADs that are in the def file.
If I follow the route specified in the manual, create an idf file, then load def, then I get 2 pictures, but I need the PADs to look like the first one
If I ask a question in the wrong section, please write where I could ask it?
Thanks in advance for your answer
In cadence allegro I would like to create a die according to the size of the PADs that are in the def file.
If I follow the route specified in the manual, create an idf file, then load def, then I get 2 pictures, but I need the PADs to look like the first one
If I ask a question in the wrong section, please write where I could ask it?
Thanks in advance for your answer