madscientist132
Newbie level 1
I am learning about Altium by means of the tutorials. I could trace a scheme with some ic's and other components and
using some tools i could start the pcb stage. Even i could give the physical position on the board.
Not all runs that fine:
While i work on positioning each ic and some caps and resistors, in the top left corner of the board there's a brownish to gray message zone wich displays my coordinates and some circuit details. Sometimes it gets big enough to get between my mouse pointer and the board sheet itself and it's making my work really hard. Is it feasible in Altium to configure and or suppress that detail completely and have the pcb workspace free of obtrusive indicators?
using some tools i could start the pcb stage. Even i could give the physical position on the board.
Not all runs that fine:
While i work on positioning each ic and some caps and resistors, in the top left corner of the board there's a brownish to gray message zone wich displays my coordinates and some circuit details. Sometimes it gets big enough to get between my mouse pointer and the board sheet itself and it's making my work really hard. Is it feasible in Altium to configure and or suppress that detail completely and have the pcb workspace free of obtrusive indicators?