ICD3 & PICKIT3 debuggers don't debug

Status
Not open for further replies.
L

LOSTISLAND

Member level 3
Joined
Jun 8, 2010
Messages
54
Helped
6
Reputation
12
Reaction score
5
Trophy points
1,288
Visit site
Activity points
1,682
ICD3 & PICKIT3 debuggers don't debug

Hi all ,
Even though ICD3 & PICKIT3 programmers work properly , ICD3 & PICKIT3 debuggers don't debug

Configuration bits :
__CONFIG _CP_OFF & _MCLRE_OFF & _WDT_OFF & _PWRTE_ON & _INTRC_OSC_NOCLKOUT

IDE :
MPLAB IDE 8.73

Toolsuit :
MICROCHIP MPASM Toolsuit

Microcontroller :
PIC16F639


This is the error while trying to debug when the debugger ICU3 is selected :

ICD3Err0040: The target device is not ready for debugging.
Please check your configuration bit settings and program
the device before proceeding.

Thanks in advanced

- - - Updated - - -

Here's the programmer connector :

 

PIC16F639 has no built-in ICD support. A special ICD devices is required, see datasheet paragraph 12.16 In-Circuit Debugger.
 
Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…