ICD2 clone is not working with MPLAB 8.1 for DSPIC 30F

[rameesha23]

mplab 7.5

I tried to program a DSPIC 30F2010 and 30F3011 with slotz icd2 but not working with new MPLAB version 8.1. I check them with older MPLAB version 7.5v and both chips programed perfectly. What could be the wrong. Is that microchip taking some action against ICD clones in future. Problem is most new pic are only supportted in new 8.1 MPLAB version and may not possible to program them in future. If you know any solution for this pls help.

Thanks

chamalee

 

[JOPEN]

icd2 invalid target dspic

I have same problem as you in MPLABv8.1.

I use stolz.de.be version and work fine with 16F & 18F series.

When it comes to dsPIC30F series, device id always invalid (0x0)

I have checked all the pin on dsPICF4011
Vdd AVdd ->5V
Vss AVss ->Ground
and a 7.373Mhz oscillator with 15uF



Can anyone help me?

 

[senthilkumar]

mplap 8.1

can you apply vdd as 3.3V and try?

 

[JOPEN]

dspic mplab

it still the same.
not working.

Connecting to MPLAB ICD 2
...Connected
ICDWarn0030: MPLAB ICD2 is about to download a new operating system. If MPLAB IDE is just starting, it will appear to "hang" at the splash screen. Please be patient. MPLAB IDE will finish it's intialization after the OS is downloaded. (Note: You may wish to select to ignore this warning in the future.)
Downloading Operating System
Connecting to MPLAB ICD 2
...Connected
Setting Vdd source to target
ICDWarn0020: Invalid target device id (expected=0x101, read=0x0)
...Reading ICD Product ID
Running ICD Self Test
... Failed Self Test. See ICD2 Settings (status tab) for details.
...Download Operating System Succeeded
Setting Vdd source to target
ICDWarn0020: Invalid target device id (expected=0x101, read=0x0)
...Reading ICD Product ID
Running ICD Self Test
... Failed Self Test. See ICD2 Settings (status tab) for details.
MPLAB ICD 2 Ready

 

[rameesha23]

mplab ide version 7.5

Jopen:

What is the pic you are trying to program if it is 30F family then i suggest you to try that with MPLAB 7.5 or below 8.0. I can still program 18f and 16F series with MPLAB 8.1 but not 30F series.

I still can program the 30F with MPLAB 7.5

 

[JOPEN]

mplab ide 8.1

YAHOOOOOOOOOOOOOOOOOOOOOO!!

Since I change MPLAB to 7.5
it works!!!


Thanks to rameesha23

 

[rameesha23]

icd2 invalid target device expected 0x101

I am happy you solved your problem but i could not solved mine I need some how make MPLAB 8.1 or later to work for our ICD2 because most newer pics specialy 3.3V ones are only supported in this later versions. Any help ....