Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

IBIS models cut and paste?

Status
Not open for further replies.
J

Jester

Full Member level 6
Full Member level 6
Joined
Aug 18, 2012
Messages
377
Helped
7
Reputation
14
Reaction score
7
Trophy points
1,298
Location
.
Activity points
4,754
I have an accurate IBIS model for the processor side of a SERDES interface, however the IBIS model for the PHY chip has "NoModel" for the SERDES pins. I'm thinking of editing the IBIS model for the PHY chip to include the SERDES model information from the processor (better than no model). Has anyone done this before and did it work?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top