[PIC] I2C Bus Speed Requirements

Status
Not open for further replies.
V

VirusX2

Member level 4
Joined
Nov 18, 2014
Messages
77
Helped
1
Reputation
2
Reaction score
0
Trophy points
1,286
Visit site
Activity points
1,855
Hello everyone, i'm old reader but new member in this forum..!!

I'm currently working on a Real-time measurement system to measure voltage, current, frequency and some other electrical signals. The heart of my system is a PIC18F4553 and as communication protocol i must use I2C cause for every measurement there will be a subsystem on separate PCB. My problem is what bus speed i really need..? 400 KHz or i must go to 3.4 MHz. I want basically to communicate with A/D converters. The fastest i found produces 189 kSPS (Samples/Second) so can take sample every 5.2 μS. It's supports all I2C speeds. How can i calculate what bus speed i really need?
 

The method explained here is for finding data bus speed(s) in CPUs.The connection(s) between the CPU peripherals connected by the bus are not very different from the connection(s) you are having in your measurement system.It should give you a basic idea.
https://www.smxrtos.com/articles/whiteppr/flashperformance.htm
 

There aren't much I2C devices that support 3.4 MHz "Hs" mode. PIC processors e.g. don't.
 

How can i calculate what bus speed i really need?
Click to expand...
Your PIC has an SPI peripheral that can go faster then I2C - why not use it instead?
 

FvM said:
There aren't much I2C devices that support 3.4 MHz "Hs" mode. PIC processors e.g. don't.
Click to expand...
Are you sure..? I am programming my PIC with 3.4 MHz speed at I2C parameters and no error occurs.

shaiko said:
Your PIC has an SPI peripheral that can go faster then I2C - why not use it instead?
Click to expand...
Cause i need the hot-plug and the build-in acknowledgment functions of I2C bus..
 

I am programming my PIC with 3.4 MHz speed at I2C parameters and no error occurs.
Click to expand...
Maybe it works by chance, but not according to PIC specification. Hs-mode uses special push-pull drivers which are not provided by PIC hardware.
 

shaiko said:
Your PIC has an SPI peripheral that can go faster then I2C - why not use it instead?
Click to expand...

What type of cable is suitable for SPI communication (at 2.5 - 5 MHz), max length about 30-40 cm? I am thinking about UTP CAT5. I want this to connect the main pcb with the sub-pcb where the ADC is located.
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…