I want to send data at 100mbps with Rabbit processor without changing connectors

Status
Not open for further replies.
V

vikky

Full Member level 3
Joined
Oct 18, 2007
Messages
150
Helped
4
Reputation
8
Reaction score
3
Trophy points
1,298
Activity points
2,664
I have done a firmware using Rabbit processor 3000 and sending data at 10mbps.now i want to send the data with 100mbps speed and i dont want to change the mechanical design or PCB Size.i.e connectors shud remain same(MAC Jack).
 

Re: Rabbit processor

OK, What is your question?
--
Amr
 

Re: Rabbit processor

Rabbit3010 cannot support 100mbps...how can i replace it with my restrictions in PCB and mechanical design?
 

Re: Rabbit processor

You have to change your design then. If you are lucky, you can find a successor with 100% pin matching.

--
Amr
 

Rabbit processor

i thought of using 5700 but the MAC jack is not matching.i am ready to change my design but not my connectors.there is where lies my problem.
 

Re: Rabbit processor

Well, if it is only the MAC connector, it is a low price for the change.
You have to do a cost-benefit analysis to reach your decision.
--
Amr
 

Rabbit processor

it is not price but compatibility which worries me.
 

Re: Rabbit processor

This is interpreted as a price as well.
--
Amr
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…