Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Hyperterminal troubleshooting

Status
Not open for further replies.
A

amila133

Member level 4
Member level 4
Joined
Oct 13, 2009
Messages
72
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,288
Location
Sri Lanka
Activity points
1,746
Hi,

I used hyperterminal to control GSM phone through AT commands. Phone is connected well. But I can not type on hyperterminal.
what are the reasons for this.
Thanks..

Added after 44 minutes:

Also the response of the modem is also not displayed in terminal
 

Use Tera Term. That's much better.
 

You may have "Flow Control" set to Hardware but not have those lines connected. Try it with "Flow Control" set to None - it's under Port Settings
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top