hyperterminal software require

[imranahmed]

Please let me know that where&which i find HyperTerminal software connect to proteus or any microcontroller by using serial port.

 

[internetuser2k12]

proteus has its own Virtual Terminal. You can use RealTerm.

 

[hemnath]

check it. it may help you .

https://www.youtube.com/watch?v=gwkju6f2Twk

 

[imranahmed]

I also need externally connected circuitry status measurements for example analog data of temperature sensor , adc values etc...

 

[internetuser2k12]

I also need externally connected circuitry status measurements for example analog data of temperature sensor , adc values etc...

What do you want?

 

[imranahmed]

I want to display adc reading or analog readings on hyperterminal.

 

[internetuser2k12]

I said to use hyperterminal. zip and post your project files and proteus file.

if your adc reading is 126 then send it as it is to uart, if that doesn't work then convert 126 into '1', '2', and '6' and send each char to uart.
You have to set the baud rate properly in hyperterminal and also in your PIC. Are you using Windows XP?

 

[imranahmed]

I am using Windows XP and i found hyperterminal.zip in thread and i am making project after some time i will send you may be 1 or 2 days.

 

[Tahmid]

Are you going to be simulating in Proteus only?

Or will you make the circuit on hardware as well? If so, make sure you construct the hardware properly, especially the "level converter" based on the MAX232 (or some other similar chip).

If simulating on Proteus only, you can just use the Virtual Terminal in Proteus without the level converter.