HV9910B draws just 1mA of bias current

Status
Not open for further replies.
T

treez

Guest
Page 4 of the HV9910B datasheet says it draws about 2mA of bias current (i am not including the FET drive current here).

Can it really be this low?

Surely the internal linear regulator alone would draw more bias current than that?


HV9910B datasheet
**broken link removed**
 

Surely the internal linear regulator alone would draw more bias current than that?
Click to expand...
Surely not. Why should it?
 
Reactions: treez

    T

    Points: 2
    Helpful Answer Positive Rating
Surely not. Why should it?
Click to expand...

OK but i just cannot get over this pwm controller needing just a meagre 2mA to run itself.........the old UC3843 pwm controllers draw around 14mA.

2mA seems unbelievably good?

High voltage input linear regulators usually use high voltage pass transistors, which have a low hfe, meaning they need a high base current to work.......but the linear regulator inside the HV9910B doesnt seem to be afflicted by these disadvantages...why?
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…