Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to switch from low to high voltages

Status
Not open for further replies.
H

hemant03

Junior Member level 1
Junior Member level 1
Joined
Jul 17, 2007
Messages
16
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,389
Hi,
I have a signal that comes out of the op-amp circuitry working on 15V power supply. Since I am supposed to use in the programming chip, I have to reduce the voltage level.
Now the output from CPLD is supposed to go to the circuitry operating at 15V logic level. How do I accomplish this. Any clues?

Thanks,
- Hemant
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top