how to show pin out in a layer-gerber-using 16.5?

Status
Not open for further replies.
D

danismith

Member level 2
Joined
May 29, 2013
Messages
47
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
1,584
hi,
i have completed my board with single layer successfully.but when i gave the board for fabrication i got a reply that,i need to show pin out for fabrication.
i have generated the gerber by setting the design parameter->disply->enhance display mode (all in ON condition).

but he is keep on telling the same message to show the pins, on the layer.

so help me how to do this?
 

I don't think that "pin out" is a clear term related to PCB. Which information is missing in the gerber data? I presume you are talking about PCB fabrication, not assembly?
Necessary files for a single layer board are
- signal (copper)
- soldermask
- board outline
- NC drill
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…