msdarvishi
Full Member level 4
- Joined
- Jul 30, 2013
- Messages
- 230
- Helped
- 1
- Reputation
- 2
- Reaction score
- 1
- Trophy points
- 18
- Activity points
- 2,349
Hello everybody,
I am working on DCM operating at 450MHz in Virtex-5 FPGA with SPEED GRADE -1 in MAXIMUM SPEED. I used an internal clocking by setting the clock on LOC = AG18 in UCF. I would like to know how can I monitor this signal with oscilloscope. The board that I use is Xilinx Gensys Virtex-5 with XC5VLX50T device. Also, the PMOD connectors in this board are located in AD11, AD9,...
Thank you,
I am working on DCM operating at 450MHz in Virtex-5 FPGA with SPEED GRADE -1 in MAXIMUM SPEED. I used an internal clocking by setting the clock on LOC = AG18 in UCF. I would like to know how can I monitor this signal with oscilloscope. The board that I use is Xilinx Gensys Virtex-5 with XC5VLX50T device. Also, the PMOD connectors in this board are located in AD11, AD9,...
Thank you,