How to reduce noise in HTRC110

Status
Not open for further replies.

kandhu26

Member level 5
Joined
Sep 7, 2009
Messages
93
Helped
13
Reputation
26
Reaction score
12
Trophy points
1,288
Location
chennai / bangalore
Activity points
1,858
I am using HTRC110 is interfaced with Xmega32a4 controller... Clk, Dout, Din these 3 pins of htrc110 interfaced with controller... When i am not showing the card the Dout pin of htrc110 should be high... But The Dout is toggling continuously[i.e. noise is high]....Can any 1 help me how to reduce these noise... Because of these noise tag reading speed has got decreased...
 

I am having the same problem with the HTRC110 chip. When I initiate a read command the DOUT pin toggle even when no tag is within range of the reader. Have you found a solution to this yet?

Thanks,

Kevin
 

Hi, I took over USB RFID reader project after my former coworker and I´m dealing with the same problem. The HTRC circuit is powered directly from USB voltage (no voltage regulator or isolator), throught ferrite bead to 100nF and 10uF capacitors in paralel.

I think the problem lies in unstable supply voltage, because if i connect the HTRC to a separated voltage source, DOUT noise disappear and signal stay in hi level for all the time.

Am I right or can be this problem be caused by other influence? Can you give me any advice how to clear USB sypply voltage?
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…