Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to reduce back drilling cost in PCB

Status
Not open for further replies.
H

hioyo

Advanced Member level 4
Full Member level 1
Joined
Aug 18, 2021
Messages
116
Helped
0
Reputation
0
Reaction score
2
Trophy points
18
Activity points
899
Dear Team,

May I know things needs to be taken care for reducing the back drilling cost in pcb.

Regards
HAu
 

Sort by date Sort by votes
I second that emotion... HDI design gives far more control... except where press-fit edge connectors are used.
Other than that limit the amount of back-drilling required where possible.
 
  • Like
Reactions: hioyo

    H

    hioyo

    Points: 2
    Helpful Answer Positive Rating
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top