BrownieHaHa
Newbie level 5
I have a small question to ask everyone (although it's a small issue, it's a bit OCD-inducing and also affects work efficiency):
Every time I open a layout with Virtuoso Layout XL, if there is a schematic, it automatically pops up the physconfig window, as shown in Figure 1;
If there is no schematic, it defaults to popping up an "update connectivity" window (which is also quite annoying), as shown in Figure 2; if I click yes, it reports an error; if I click no, it reports *WARNING* (LX-2040): Cannot open cellview in Layout XL because there is no connectivity reference defined. The cellview was opened in Layout L instead.
I've searched cdshelp and looked through some user guides, but haven't found a solution. I would like to ask how I could configure cdsinit to address this?
Every time I open a layout with Virtuoso Layout XL, if there is a schematic, it automatically pops up the physconfig window, as shown in Figure 1;
If there is no schematic, it defaults to popping up an "update connectivity" window (which is also quite annoying), as shown in Figure 2; if I click yes, it reports an error; if I click no, it reports *WARNING* (LX-2040): Cannot open cellview in Layout XL because there is no connectivity reference defined. The cellview was opened in Layout L instead.
I've searched cdshelp and looked through some user guides, but haven't found a solution. I would like to ask how I could configure cdsinit to address this?