How to make avanwaves display all terminal currents (Hspice)

[sutapanaki]

Hspice question

I'm trying to learn hspice. Can someone tell me how to make avanwaves display all terminal currents without describing them one by one in the .probe command?

 

[kwkam]

It is necessary.

 

[manoj]

Re: Hspice question

this is the only way i know!!

 

[sutapanaki]

Re: Hspice question

It is hard to me to believe there is no other way. I'm using eldo on a daily basis and its syntax is very similar in a way to hspice (not everything though). There for example if you put .probe i you get all the currents in the schematic. But I think this doesn't work with hspice.

 

[shiowjyh]

Re: Hspice question

Hello,
There is a easy way to monitor currents, but only for Device current at one specific time.
.op all 'time_you_want_to_measure'

Then, check your dump *.lis file.
Since every device current were known, It would not be very hard to calculate your node current..


Regards,

 

[Areky_qin]

Hspice question

in your simulatio netlist ,add the
.probe v(*) ,i(*)

this command means display all the node voltage and all terminal's currents.
Best regards.