Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

How to make automatic measurements and data logging !!

Status
Not open for further replies.

matrix1

Junior Member level 1
Junior Member level 1
Joined
Mar 21, 2005
Messages
17
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,453
Hi all
I need to make automatic measurements and data logging of various parameters of a waveform using Oscilloscope, e.g. Amplitude, frequency, rise/fall time, overshoots etc. Is that possible using a Scope or how should i proceed to record certain events and failures during testing an equipment. Secondly this is manchester bi-phase data so whole frame or at least a word must be record in terms of voltage, freq, Amplitude etc.
Any other suggestion to develop a testing system which can perform various tests on an equipment according to a certain standards. thanks

Zafar
 

You may develop Automated Test Equipment using PXI modules and industry standard leading software like NI Test Stand or NI Labview.

Please refer to the website www.ni.com/pxi for details.

-TPJ
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top