How to isolate between tracks in altium?

[nxt_]

Dear all,
Greetings, i would like to know how to isolate between tracks in altium 10 designer after finishing the pcb, i mean like in Eagle. (after you finish the routing and everything you just set the ratio and the program do the rest.) so i am asking how to do that in altium.

i am using photo resist technique as pcb manufacturing process. so i need to output file with holes ,vias,tracks including isolation to be printed.

Thanks.

---------- Post added at 01:38 ---------- Previous post was at 01:28 ----------

sorry its altium 09 not 10..

 

[joeyla]

You can follow this guide for outputting your Gerbers from Altium. It also shows how to setup Clearances ( Isolation ) although this does need to be done before you route or you'll end up re-doing the layout where violation occur.

**broken link removed**