Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to decide upon the length of 45 degree bends in routing layers?

Status
Not open for further replies.
B

bollu

Newbie level 5
Newbie level 5
Joined
Apr 5, 2006
Messages
8
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
BANGALORE,INDIA
Activity points
1,350
Hi all,

i will be thankfull if some body could tip me on how to decide upon the length of 45 degree bends in routing layers.

Thanks,
bollu.
 

Re: layout routing

the length u need to take depends on the nodes and distance between which u connecet.
Always try to take single 45 bend between two nodes and no acute angle
Regards
 

    B

    bollu

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top