How to connect 1HP DC servo motor in mC 8051?

Status
Not open for further replies.
J

Jagan EC

Newbie level 4
Joined
Sep 7, 2013
Messages
7
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Visit site
Activity points
46
Hi Friends..,

i have use 1HP DC servo motor..,

how to connect mC 8051?
plz give circuit diagram.

How to rotate 45 Degree angle & 90 Degree Angel using 8051?
plz give me code..,

Plz help me friends..,
 

I have never used a 1 HP servo. I have used little 1.5 inch long servos.

These have 3 wires. Two are red and black, and go to the power supply.

The third wire is the control line. It requires a pulse which varies between 1 and 2 milli-Seconds. The length of the pulse shall be in proportion to the position you want it to move to. Its movement is within a 190 degree arc.

50 per second is a typical frame rate for control pulses.

The above applies to small servos such as are used in radio controlled planes / boats / cars. Your servo motor may or may not operate the same way.
 

use PWM and a linear driver to do interfacing then construct a closed loop with shaft encoder. By using PID loop control complete your closed loop.after these steps you need to adjust PID parameter.
 



I try to bulid pipe bending machine..,
so High torque Motor need...,
plz sugestion any idea???
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…