Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to check Whether the signal is in Margin after simulation?

Status
Not open for further replies.
N

Nitan

Newbie level 5
Newbie level 5
Joined
Oct 30, 2012
Messages
9
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,327
Hi

Im practicing SI on Reflection and Cross talk for SDCK net between "AT91SAM ARM-based Embbedded MPU" & Micron SDRAM.
I have assigned the stackup in cross section and IBIS model also for these two ICs. As per the guideline given, i have done simulation, im getting overshoot of about 4.7V and cross talk of about 450mV.
After appending series termination my overshoot got reduced and im not sure about cross talk whether that is within the margin or outside the margin.
Can you please guide me to get these details? Where can i find this detail?

Original part numbers
AT91SAM9260-QU
MT48LC16M16A2P-75 IT

Thanks,
Nitan
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top