how to calculate the value of resistor?

Status
Not open for further replies.
H

hemnath

Advanced Member level 3
Joined
Jun 24, 2012
Messages
702
Helped
61
Reputation
120
Reaction score
57
Trophy points
1,308
Location
Chennai
Visit site
Activity points
6,589
I'm using zener diode 1N5239. and my input voltage is 24V. I have to connect the resistor to make current flow through the zener diode. How to calculate the value of resistor and what is the possible current to flow through the zener? Please look into 1N5239 datasheet and tell. Please help!!!
 

Thats a 9.1v, 500mW zener.

This implies it can handle a max current of ~55mA ( VxI = W ). So anything less than this is OK.
Now, we need a series resistor which must drop (24 - 9.1 =) 14.9v, and ensure that current is less than 55mA....

SO R = V / I = 14.9/ 0.055 ~ 271 ohm.

Any resistor value >= 271 ohm will do the job.
 
No specific minimum, but zeners work better at high currents than low. e.g. 10mA will be much better than 1mA. The datasheet I looked at used a test current of 20mA.

Maybe just use a 1K 1/2 Watt resistor. That will give about 15mA, which should be fine.

To give an idea of the change in performance with current, the datasheet says Zener impedance = 10 Ohms at 20mA, 600 Ohms at 0.25mA. (lower is better)
 
Last edited:

Is it possible to allow uA to zener. I couldn't allow 10mA because i'm designing a battery operated device. Even 1mA is more current in my design.
for example 6V is my input voltage and using 3V1, 500mW zener. so maximum current could be 161mA. So i can use any resistor value greater than 18 Ohms. Is it right?
So if i use 100K resistor, current flow through the path will be 29uA. But i could not get steady 3V. How to achieve ? please help
 

Hi,for zener diode,it's mandatory to bias at certain mA result from zener mechanism.If bias uA,a voltage reference is available.
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…