[SOLVED] How to achieve 5A short circuit and maximun current for series voltage regulator?

Status
Not open for further replies.
H

hanshen

Junior Member level 1
Joined
Oct 31, 2010
Messages
18
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Visit site
Activity points
1,409

The figure shows multimeter at the output is in Ammeter mode which i think it functions as short circuit for the system.

Referring the picture, I attached. I have designed a series voltage regulator that can convert AC source to DC source (range from 0 - 20V). However, I could not achieve 5A maximum current (short circuit current). Initially, I thought it was the component that restraint me from achieve the maximum current desired. So I did change some of the component with higher power rating. However it seems to make no difference. Can someone point out where i make a mistake in designing the power supply.
 

The 2N3055 likely doesn't have enough gain to deliver 5A from the limited output current of a 741. One option is to make it a Darlington pair (such as by adding a 2N2222).

You are aware that the 5A short circuit power dissipation will be over 150W with a 24VAC rectified supply(?). So continuous short circuits will require a humongous heat sink.
 

I have tried in the simulation. You are right. Thanks a lot. I have spend a few hours, yet the fact that 2N3055 do not have enough gain just didn't cross my mind. Thanks again.

Regarding the power dissipated, thanks for the reminder. I will put that in mind. I will try to redesign the short circuit protection part.
 

hanshen said:
..................................
Regarding the power dissipated, thanks for the reminder. I will put that in mind. I will try to redesign the short circuit protection part.
Click to expand...
You can reduce the dissipation by going to fold-back or hiccup type limiters. These reduce the average short-circuit current.
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…