ziobleed
Newbie level 6
Hi all
Im working on a project of amlifier on AWR microwave office and CST
, 1) i designed it on AWR, optimized it
2) i exported the layout on CST via .DXF file and designed the circuit on CST
3) i measure the s parameters of the project on cst
but
4) when i put them on MWO again , the results are very different
so my question :
How can i implement on CST the same enviroment ( ie : same boundary conditions, the same metal,sover settings, the same circuit etc etc ) to obtain a circuit with the behaviour predicted by MWO ?
another question : is the above procedure correct ?
zb
Im working on a project of amlifier on AWR microwave office and CST
, 1) i designed it on AWR, optimized it
2) i exported the layout on CST via .DXF file and designed the circuit on CST
3) i measure the s parameters of the project on cst
but
4) when i put them on MWO again , the results are very different
so my question :
How can i implement on CST the same enviroment ( ie : same boundary conditions, the same metal,sover settings, the same circuit etc etc ) to obtain a circuit with the behaviour predicted by MWO ?
another question : is the above procedure correct ?
zb