How is drawing output power variation versus 2parameter in ADS??

Status
Not open for further replies.
P

perado

Full Member level 2
Joined
May 28, 2010
Messages
127
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,298
Activity points
2,134
I want to change 2 parameter of a circuit ( for example 1-value of a inductor and 2-width of a transistor) simultaneously and after simulation can plot output power of my circuit versus 2parameters variations.
What I should do in schematic window in ADS?
 

U can set the variable as sweep variables and perform the simulation.
 

I know that how sweep one parameter by selecting sweep tab in HB-simulation engine and define desired parameter but I dont know how it is possible to sweep 2 parameters simultaneously??
 

sweep 2nd parameter based on 1st sweep......check ADS help for multisweep plans...
 
Reactions: perado

    P

    perado

    Points: 2
    Helpful Answer Positive Rating
Add as many Parameter Sweep (ParamSweep) blocks as you have variables to sweep.
 
Reactions: perado

    P

    perado

    Points: 2
    Helpful Answer Positive Rating
I do it but I want to show simulation results in 3D format, how it is possible??
 

U want to see the results as such as those variations then try ( : : )operator check data accessing options in help
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…