[SOLVED] How can you find an ideal target insertion delay before performing CTS?

iamcharlz · Mar 29, 2014

How can I find an ideal "target insertion delay" based on my design to enter before performing CTS?

ro9ty · Apr 10, 2014

You cannot... you can just estimate. Your target insertion delay should be such that your skew is not very high and for that you will have to do some dummy runs.
However, thumb rule says skew should be as low as possible. So for a design with 20MHz (50ns clock period) 0.5ns skew means 1% which might be acceptable depending on how prone your design is to timing violations. but the same 0.5ns for 200MHz would mean 10% violation and that in any design is not acceptable.

iamcharlz · Apr 10, 2014

Thanks for the reply... r09ty!!

[SOLVED] How can you find an ideal target insertion delay before performing CTS?

iamcharlz

Newbie level 3

ro9ty

Member level 4

iamcharlz

Newbie level 3

Similar threads

[SOLVED] How can you find an ideal target insertion delay before performing CTS?

iamcharlz

Newbie level 3

ro9ty

Member level 4

iamcharlz

Newbie level 3

Similar threads

Privacy & Transparency

Privacy & Transparency