majidmad
Junior Member level 2
Hi
I have a problem in designing a micro strip feeding in CST.
when I design a coaxial feeding , I define coax entrance for port, for example I select dielectric's face of coax for port.
But when I design a micro strip line as port, CST make an error that says the port can not contain completely from PEC !
does any body know what is may fault in design ?javascript:emoticon('')
best regards
I have a problem in designing a micro strip feeding in CST.
when I design a coaxial feeding , I define coax entrance for port, for example I select dielectric's face of coax for port.
But when I design a micro strip line as port, CST make an error that says the port can not contain completely from PEC !
does any body know what is may fault in design ?javascript:emoticon('')
best regards