Home security system programming

Status
Not open for further replies.

binojkumar

Full Member level 3
Joined
Jul 19, 2004
Messages
151
Helped
2
Reputation
4
Reaction score
1
Trophy points
1,298
Location
Bangalore
Visit site
Activity points
983
most of the home security system control panel input has a voltage (6vdc maximum) if we measure with respect to ground. After connecting the sensor with a series resistor(5.6k used), the voltage at input pin reduced. In open circuit maximum voltage will present in the input pin(6v), closed circuit voltage will be reduced.

How the same we can program with a micro controller(PIC)/?
 

Use the sensor to drive a small relay, then use the relay contact to drive the alarm input.
 

Status
Not open for further replies.

Similar threads

Cookies are required to use this site. You must accept them to continue using the site. Learn more…